Husqvarna 701 Enduro 2017 Owner's Manual page 179

19 CLEANING, CARE
–
Close off the exhaust system to keep water from entering.
–
Remove loose dirt first with a soft jet of water.
–
Spray very dirty parts with a normal commercial engine cleaner and then brush off
with a soft brush.
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always rinse the vehicle with
water first.
If the vehicle was operated in road salt, clean it with cold water. Warm water
401061-01
would enhance the corrosive effects of salt.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Moisture and dirt impair the brake system.
–
–
After cleaning, ride the vehicle a short distance until the engine warms up.
Info
The heat produced causes water at inaccessible locations in the engine and on
the brake system to evaporate.
–
Push back the protection caps of the handlebar controls to allow any water that has
penetrated to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. (
Brake carefully several times to dry out and remove dirt from the brake lin-
ings and the brake discs.
p. 88)
177