Husqvarna 701 Enduro 2017 Owner's Manual page 123

13 BRAKE SYSTEM
–
Stand the vehicle upright.
–
Remove screw cap
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
piston. Ensure that brake fluid does not flow out of the brake fluid reservoir, extracting
it by suction if it does.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
V00517-10
–
Remove cotter pin
brake linings.
–
Clean the brake caliper and brake caliper support.
D00955-10
–
Check that leaf spring
support are seated correctly.
–
Insert the new brake linings, insert the pin, and mount the cotter pins.
Info
Always change the brake linings in pairs.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
400419-11
 
with membrane .
 , remove pin  toward the left by striking it, and remove the

in the brake caliper and sliding plate
121

in the brake caliper