Checking The Free Travel Of Foot Brake Lever - Husqvarna 701 Enduro 2017 Owner's Manual

13 BRAKE SYSTEM
13.8

Checking the free travel of foot brake lever

Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
–
Check that leaf spring
support are seated correctly.
–
Insert the new brake linings, insert the pin, and mount the cotter pins.
Info
Always change the brake linings in pairs.
–
Operate the hand brake lever repeatedly until the brake linings are in contact with the
brake disk and there is a pressure point.
400418-10
–
Correct the brake fluid quantity to level
Guideline

Level
Brake fluid DOT 4 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilled brake fluid immediately with water.
V00502-12

in the brake caliper and sliding plate
 .
5 mm (0.2 in)
p. 200)
113

in the brake caliper