Show Netio Subblock - Cisco XR 12000 Reference

Troubleshooting Commands

show netio subblock

To display Network Input and Output (Netio) subblock information, use the show netio subblock command
in EXEC mode.
show netio subblock {idb {interface typeinterface-instance} | registrations } [location node-id]
Syntax Description
idb
registrations
interface-type
interface-instance
location node-id
Command Default
No default behavior or values.
OL-30353-01
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
Displays subblock information for an interface.
Displays all the registered subblocks.
Interface type. For more information, use the question mark
(?) online help function.
Either a physical interface instance or a virtual interface
instance as follows:
• Physical interface instance. Naming notation is
rack/slot/module/port and a slash between values is
required as part of the notation.
◦ rack: Chassis number of the rack.
◦ slot: Physical slot number of the modular
services card or line card.
◦ module: Module number. A physical layer
interface module (PLIM) is always 0.
◦ port: Physical port number of the interface.
Note In references to a Management Ethernet
interface located on a route processor card,
the physical slot number is alphanumeric
(RP0 or RP1) and the module is CPU0.
Example: interface MgmtEth0/RP1/CPU0/0.
• Virtual interface instance. Number range varies
depending on interface type.
For more information about the syntax for the router, use
the question mark (?) online help function.
(Optional) Displays Netio subblock information for a
specified node. The node-id argument is entered in the
rack/slot/module notation.
show netio subblock
67