show tech-support dsc
show tech-support dsc
To automatically run show commands that display information specific to designated shelf controller (DSC)
debugging, use the show tech-support dsc command in Administration EXEC mode.
show tech-support dsc [location node-id] {terminal [page]| file send-to [background] [compressed|
uncompressed]}
Syntax Description
location
node-id
terminal
page
file
sent-to
background
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
192
(Optional) Specifies a node.
(Optional) Node ID. The node-id argument is entered in the rack/slot/module
notation.
Displays the command output on the terminal.
(Optional) Displays the command output on a single page at a time. Use the
Return key to display the next line of output or use the space bar to display the
next page of information. If not used, the output scrolls (that is, it does not stop
for page breaks).
Press the Ctrl-C keys to stop the command output.
Specifies that the command output is saved to a specified file.
Name of the file. The following are valid options:
• filename
• bootflash: filename
• compactflash: filename
• disk0: filename
• disk1: filename
• flash: filename
• ftp: filename
• harddisk: filename
• harddiska: filename
• nvram: filename
• rcp: filename
• slot0: filename
• slot1: filename
• tftp: filename
(Optional) Specifies that the command runs in the background.
Tech-Support Commands
OL-30353-01