Configuring The Call Parking Screen - ZyXEL Communications X6004 User Manual

Chapter 21 Call Services
Table 103 Call Parking Progression
CALLER A

21.7.1 Configuring the Call Parking Screen

Use this screen to configure call parking on the X6004. Click Configuration > PBX > Call
Services > Call Parking to open the screen.
Figure 242 Call Parking Configuration
The following table describes the labels in this screen.
Table 104 Call Parking Configuration
LABEL
Call Parking
Setting
Representative
Number
Amount of
Parking
Position /
ZyStack
Parking Time
Apply
Reset
266
X6004
5. The X6004 parks the call
and informs caller B of the
number to call to reconnect
to the call. This is called the
parking slot number.
Conversation between caller A and B continues
DESCRIPTION
Enter the telephone number users should dial to park a telephone call.
Enter the number of call parking extensions available. This also establishes the
range of numbers that users will have to dial to retrieve a parked call.
Enter the maximum number of seconds that a call can be parked. After a parked call
exceeds this amount of time, it is routed back to the original extension that parked
the call.
Click this to save your changes and to apply them to the X6004.
Click this to set every field in this screen to its last-saved value.
CALLER B
4. Caller B transfers the call to
the call parking lot. (This is
done by dialing # followed by
the parking lot number.
6. Caller B walks to another
extension and reconnects to
the call with A by dialing #
followed by the parking slot
number.
X6004 User's Guide