The Packet Capture Screen - ZyXEL Communications X6004 User Manual

Table 138 Maintenance > Administration > Diagnostic > Information Collect
LABEL
Size
Download

28.3 The Packet Capture Screen

Use this screen to log network traffic going through the X6004 LAN or WAN interface. This
feature is for a debug administrator only (see
Administration > Diagnostic > Packet Capture to view the screen as shown.
Figure 283 Maintenance > Administration > Diagnostic > Packet Capture
Each field is described in the following table.
Table 139 Maintenance > Administration > Diagnostic > Packet Capture
LABEL
Machine ID
Interface
Host
Protocol
X6004 User's Guide
DESCRIPTION
This field displays the size of the file.
Click Download to save the file to your computer.
DESCRIPTION
If you have more than one X6004 configured in a ZyStack, select the one from
which you want to collect information.
Choose the interface for which you want to log network traffic.
Optionally, limit the capture of information to communication with a specific
network device. Enter the IP address of the network device that the X6004 is
communicating with. You can also enter the IP address of the X6004 itself, in
which case, the X6004 only collects information where the destination or source IP
matches that of the X6004.
Specify the protocol type which you want to capture information on. You can
choose TCP, UDP, ICMP or select All to capture all IP traffic going through the
X6004.
Section 27.3 on page 318). Click Maintenance >
Chapter 28 Diagnostics
323