The Www Screen - ZyXEL Communications X6004 User Manual

Requirements for Using SSH
You must install an SSH client program on a client computer (Windows or Linux operating
system) that is used to connect to the X6004 over SSH.
ICMP
Internet Control Message Protocol is a message control and error-reporting protocol between a
host server and a gateway to the Internet. ICMP uses Internet Protocol (IP) datagrams, but the
messages are processed by the TCP/IP software and are directly apparent to the application
user.

30.2 The WWW Screen

Use this screen to configure trusted computers which is allowed to access your X6004's World
Wide Web. Click Maintenance > Administration > Remote Management to display the
WWW screen.
Figure 286 Remote Management: WWW
The following table describes the labels in this screen.
Table 141 Remote Management: WWW
LABEL
Enable WWW
Remote
Management
White List
#
Access Interface
Address
Add
X6004 User's Guide
DESCRIPTION
Select this to allow only computers which use IP addresses listed in this screen to
access your X6004 via an HTTPS connection.
This field displays the index number of records in this table.
This field displays the interface(s) through which a computer may access the
X6004 using this service.
This field displays trusted computers' IP addresses that is allowed to communicate
with the X6004 using this service.
0.0.0.0 displayed means all computers are allowed to access the X6004 using this
service.
An IP address displayed (for example, a.b.c.d) means only the computer is allowed
to access the X6004 using this service.
An IP address with a subnet mask displayed (for example, a.b.c.d/255.255.255.0)
means only the computers in the subnet network are allowed to access the X6004
using this service.
Click Add to add a new trusted computer record.
Chapter 30 Remote Management
329