Auto-Attendant For Sip Trunks - ZyXEL Communications X6004 User Manual

Chapter 17 Outbound Line Group
Table 81 Configure a SIP Trunk
LABEL
Codec List
Apply
Cancel

17.6.2 Auto-Attendant for SIP Trunks

Use this screen to select which auto-attendant should be used with this outbound line group.
See Chapter 18 on page 231
configure your DID (Direct Inward Dialing) settings. Click the Auto-Attendant icon in the in
the SIP Trunk section of the Outbound Group configuration screen to view the screen as
shown.
Figure 203 AA for SIP Trunks
Each field is described in the following table.
Table 82 AA for SIP Trunks
LABEL
Auto-Attendant
Apply AA
Extension
Number for Fax
Extension
Number
DDI/DID Mapping
Setting
220
DESCRIPTION
This column indicates the codec types used by these extensions. You can
organize the priority of the codecs by highlighting it and clicking the Up or Down
buttons to move the codec higher or lower in priority. The SIP extensions attempt
to use the higher priority codecs first and try the lower priority codecs next. You
can remove a codec type from being used from these extension by highlighting it
and clicking the Left button.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
for information on configuring auto-attendant. You can also
DESCRIPTION
Select the Auto-Attendant you want to use when calls come in on this outbound
line group. Select FAX if you want to forward all incoming calls on this outbound
line group to a fax machine located at a specific extension. Select Extension if
you want to directly forward all incoming calls through this outbound line group to
an extension or a hunting group number.
This field is only available if you select FAX in the Apply AA field. Type the
extension of the Fax machine you want to forward calls to.
This field is only available if you select Extension in the Apply AA field. Type an
extension or a hunting group number you want to forward calls to.
X6004 User's Guide