Table 115 Monitor > System Information - ZyXEL Communications X6004 User Manual

Chapter 23 System Information
Each field is described in the following table.
Table 115 Monitor > System Information
LABEL
System
Information
#
IP Address
ZyStack
Status
Backup By
F/W Version
Hardware
Information
#
CPU(MIPS)
Memory(MB)
File System
Trunk(port#)
DSP
IPPBX
Information
#
286
DESCRIPTION
This field displays the index number of the X6004. If you have a ZyStack
configured then this screen displays information about all the X6004 in the
ZyStack.
These two fields display the IP addresses of the WAN and LAN interfaces on the
X6004.
This field displays:
Master - if the X6004 is the master for all of the X6004s in a ZyStack. This field
also displays Master if this X6004 is set up as a stand alone IP PBX.
Slave - if this X6004 is a slave in a ZyStack.
This field displays:
On - If the X6004 is powered on.
Off - If this X6004 is not receiving power.
Displays the IP address of the X6004 that serves as the backup IPPBX for this
X6004 (only applicable in a ZyStack configuration).
This field displays the firmware version currently installed on the X6004.
This field displays the index number of the X6004. If you have a ZyStack
configured then this screen displays information about all the X6004 in the
ZyStack.
This field displays the speed of the processing chip on the X6004 in MIPS (Millions
of Instructions Per Second).
This field displays the total RAM memory available on the X6004. This is the
memory available for processing functions on the X6004.
This field displays the total memory available for the files system on the X6004.
The file system stores information such as configuration settings, CDR and voice
mail. This number is the sum of the built in flash memory and the optional hard
disk (if installed).
These fields display the number of FXO ports (ports leading to the PSTN), FXS
ports (ports leading to analog phones on your network), ISDN BRI or PRI ports
(ports leading to the ISDN) installed on the X6004.
This field displays the capacity of the DSP (Digital Signal Processing) modules
installed on the X6004. The capacity is displayed in the number of channels the
X6004 can process at any one time.
This field displays the index number of the X6004. If you have a ZyStack
configured then this screen displays information about all the X6004 in the
ZyStack.
X6004 User's Guide