The Pstn Connection - ZyXEL Communications X6004 User Manual

3.2.1 The PSTN Connection

This example assumes that the X6004 has an FXO interface card already installed (refer to the
Quick Start Guide) and that you have connected your telephone cables to the outlets that
connect to your local telephone company. The front of your X6004 should look as shown in
the following figure.
In this example, the FXO interface card is installed in slot B and ports 1-4 are used for the
connections. You will use this information in a web configurator screen later.
Figure 24 FXO Interface Card Connection
B
FXO
D
Procedure:
1 In the web configurator, click Configuration > PBX > Outbound Line Management >
Outbound Line Group to open the following screen.
Figure 25 Configuration > PBX > Outbound Line Management > Outbound Line Group
2 Click the Add icon in the FXO Trunk section to open the following screen. Enter the
name of the group (PSTN1 in this example) and click Apply. Note the Machine ID field
(this is a name automatically assigned to the X6004). In some web configurator screens,
the outbound line group is identified in the following format Machine ID:Group Name,
so in our example it is IPPBX_001:PSTN1.
X6004 User's Guide
SYS
1 2 3 4
Chapter 3 Tutorials
PSTN
57