Installing The Aileron Servos - Black Horse Model SU 26M-EP Instruction Manual Book

SU 26M-EP -
Item code: BH97
I. AILERON.

1.INSTALLING THE AILERON SERVOS.

1) Install the rubber grommets and brass
eyelets onto the aileron servos.
Aileron
4
.
Bottom side
C/A glue
C/A glue
Instruction Manual
C/A glue
C/A glue
2) Using a modeling knife, remove the cov-
ering at possition show below.
Aileron
3. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
4. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
Electric wire
thread
Bottom of wing.