Black Horse Model SU 26M-EP Instruction Manual Book page 15

SU 26M-EP -
Item code: BH97
Cut.
Elevator
pushrod
Plastic part bottom side
fuselage
Cut.
.
Rudder pushrod.
E l e v a t o r
pushrod
Bottom side.
Instruction Manual
C/A glue
INSTALLING THE RECEIVER AND BATTERY.
1. Plug the servo leads and the switch
lead into the receiver. You may want to
plug an aileron extension into the receiver
to make plugging in the aileron servo lead
easier when you are installing the wing .
Plug the battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape
to hold the foam in place.
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to
hold the battery and receiver securely in place.
As pictures below.
Do not permanently secure the receiver
and battery until after balancing the model.
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver,
for the antenna to exit.
15