Table of Contents
Advertisement
I. AILERON.
1.1.INSTALLING THE AILERON
SERVOS 1.
1) Install the rubber grommets and brass
eyelets onto the aileron servos.
Aileron
Servo 1
2. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
servo tray .
R e m o v e
covering
Bottom side
Drill a hole
1.5mm diameter
Secure
3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
4.Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
Electric wire
thread
Advertisement
Table of Contents
