Installing The Aileron - Flap Servos - Black Horse Model P47 THUNDERBOLT Instruction Manual Book

P47 - THUNDERBOLT.
INSTALLING THE AILERON - FLAP
SERVOS.
1) Install the rubber grommets and brass
eyelets onto the aileron - flap servos.
2) Using a modeling knife, remove the
covering at possition show below.
Bottom of wing.
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out,
remove the masking tape and the servo lead
from the thread.
4) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
Top of wing.
4
Remove the
covering.
Remove the
covering.
INSTRUCTION MANUAL.
Flap
servo tray.
Aileron
servo tray
Bottom side
Top side
Servo wire.
Thread.
Flap.