Table of Contents
Advertisement
SPITFIRE MK
2. INSTALLING THE AILERON SERVOS
1) Install the rubber grommets and brass
eyelets on to the aileron servos.
2) Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
Remove the covering
Servo tray
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you have
pulled the servo lead out, remove the masking tape and
the servo lead from the thread.
Item code: BH149.
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Drill a hole
1.5mm
5) Repeat the procedure to install the aileron servos
in the opposite wing half.
1) Remove the covering from the slot on the bot-
Secure
tom of the aileron.
2) Insert the control horn into the slot and secure
it by A+B Epoxy glue.
Electric wire
Instruction Manual
Electric wire
4) Place the servo into the servo tray. Center
2x10mm
3. INSTALLING THE AILERON CONTROL HORN
Aileron
control horn
1. A+B Epoxy glue
Drill a hole
1.5mm
Secure
2. Push in
5
Advertisement
Table of Contents
