Installing The Aileron Servos - Black Horse Model BH147 Instruction Manual Book

HAWKER HURRICANE
5x35mm
2
3
3x12mm
1. Oleo struts.
2. Wheels.
3. Plastic parts for bottom fuselage.
4. Plastic - engine mount.
5. Wood - motor mount.
6. Spinner.
7. Fuel Tank
8. Tail gear set.
I. AILERON
See pictures below:
Flap
1. INSTALLING THE AILERONS
Test fit the ailerons to the wing with the hinges. If the
hinges don't remain centered, stick a pin through the
middle of the hinge to hold it in position.
4
Item code: BH147.
REPLACEMENT SMALL PARTS
3x15mm
1
2x10mm
2
6
Aileron
Bottom side.
Instruction Manual
3 x 12mm
8
7
Assemble then apply drops of thin
C/A to center of hinge,on both sides.

2. INSTALLING THE AILERON SERVOS

 1) Install the rubber grommets and brass eyelets on
to the aileron servos.
 2) Using a modeling knife, remove the covering from
over the pre-cut servo arm exit hole on the aileron servo
tray / hatch. This hole will allow the servo arm to pass
through when installing the aileron pushrods.
3x25mm
4x25mm
4
3x15mm
4x70mm
5
Temporary pin to
keep hinge centered.