Installing The Aileron Servos - Black Horse Model MUSTANG P51 Instruction Manual Book

MUSTANG P51 -
1.Door mounting wheel.
2. Wheels.
3. Air retract main gear.
4. Spinner
5. Plastic part of wing
6.Plastic - enginemount.
7. Fuel tank.
8.Tail gear set.

INSTALLING THE AILERON SERVOS.


 1) Install the rubber grommets and brass
eyelets onto the aileron servos.
4
Item code: BH33 .
Bottom of wing
Cut the covering
away from the slot.
Instruction Manual
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
 2) Using a modeling knife, remove the cov-
ering at possition show below.
Bottom of wing.
Remove the covering.
 3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
 4) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
Temporary pin to
keep hinge centered.