Show Ip Rip Interface Brief - Hirschmann PowerMICE Reference Manual

Default Route Advertise

4.6.15 show ip rip interface brief

This command displays general information for each RIP interface. For this command to display
successful results routing must be enabled per interface (i.e. ip rip).
Format
Modes
Interface
IP Address
Send Version
Receive Version
RIP Mode
Link State
4.6.16 show ip rip interface
This command displays information related to a particular RIP interface.
Format
Modes
Interface
IP Address
Send version
Receive version
Both RIP Admin Mode
Link State
Authentication Type
Default Metric
The following information will be invalid if the link state is down.
Bad Packets Received
Bad Routes Received
Updates Sent
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
The default route.
show ip rip interface brief
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
The IP source address used by the specified RIP interface.
The RIP version(s) used when sending updates on the specified interface. The types
are none, RIP-1, RIP-1c, RIP-2.
The RIP version(s) allowed when receiving updates from the specified interface.
The types are none, RIP-1, RIP-2, Both
RIP administrative mode of router RIP operation; enable activates, disable de-acti-
vates it.
The mode of the interface (up or down).
show ip rip interface <slot/port>
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes. This is a configured value.
The IP source address used by the specified RIP interface. This is a configured value.
The RIP version(s) used when sending updates on the specified interface. The types
are none, RIP-1, RIP-1c, RIP-2. This is a configured value.
The RIP version(s) allowed when receiving updates from the specified interface.
The types are none, RIP-1, RIP-2, Both. This is a configured value.
RIP administrative mode of router RIP operation; enable activates, disable
de-activates it. This is a configured value.
Indicates whether the RIP interface is up or down. This is a configured value.
The RIP Authentication Type for the specified interface. The types are none,
simple, and encrypt. This is a configured value.
A number which represents the metric used for default routes in RIP updates origi-
nated on the specified interface. This is a configured value.
The number of RIP response packets received by the RIP process which
were subsequently discarded for any reason.
The number of routes contained in valid RIP packets that were ignored for
any reason.
The number of triggered RIP updates actually sent on this interface.
41