Ip Route Default - Hirschmann PowerMICE Reference Manual

Format
Mode

4.2.5 ip route default

This command configures the default route. The value for
next hop router. The
Default
Format
Mode
4.2.5.1 no ip route default
This command deletes all configured default routes. If the optional
designated, the specific next hop is deleted from the configured default route and if the optional
preference value is designated, the preference of the configured default route is reset to its default.
Format
Mode
4.2.6 ip route distance
This command sets the default distance for static routes. Lower route preference values are preferred
when determining the best route. The
optionally set the distance of an individual static route. The default distance is used when no distance is
specified in these commands. Changing the default distance does not update the distance of existing
static routes, even if they were assigned the original default distance. The new default distance will only
be applied to static routes created after invoking the
The value 255 stands for „unreachable". This means that the appropriate route is never entered into the
forwarding database.
Default
Format
Mode
4.2.6.1 no ip route distance
This command sets the default static route preference value in the router. Lower route preference values
are preferred when determining the best route.
Format
Mode
4.2.7 ip forwarding
This command enables forwarding of IP frames.
Default
Format
Mode
Routing Commands
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
no ip route <ip_addr> <subnet_mask> [{<nextHopRtr> | <prefer-
ence>}]
Global Config
is an integer value from 1 to 255
<preference>
preference - 1
ip route default <nextHopRtr> [<preference>]
Global Config
no ip route default [{<nextHopRtr> | <preference>}]
Global Config
ip route
1
ip route distance <1-255>
Global Config
no ip route distance
Global Config
enabled
ip forwarding
Global Config
<nextHopRtr>
<nextHopRtr>
and
ip route default
ip route distance
is a valid IP address of the
parameter is
commands allow you to
command.
23