Assembly And Start-Up; Installing The Device; Unpacking And Checking; Installing The Sfp Modules (Optional) - Hirschmann RS30-...U Series User Manual

2

Assembly and start-up

The devices have been developed for practical application in a harsh
industrial environment.
On delivery, the device is ready for operation.
The following steps should be performed to install and configure a switch:


Unpacking and checking



Installing the SFP modules (optional)

 Adjust DIP switch settings
Connect the terminal block for voltage supply and signal 

contact and connect the supply voltage
 Install the device on the DIN rail, grounding

Install the terminal block, start-up procedure

Connecting the data lines
2.1

Installing the device

2.1.1 Unpacking and checking
 Check that the contents of the package are complete
"Scope of delivery").
 Check the individual parts for transport damage.
2.1.2 Installing the SFP modules (optional)
Figure 9: Fast Ethernet / Gigabit Ethernet fiber optic SFP module
 Before attaching an SFP module, first remove the protective cap over the
socket.
 Push the SFP module with the lock closed into the socket until it latches
audibly in place.
Note: Only use Hirschmann SFP modules
RS20/RS30...U
Release 01 06/2012
(see page 38
(see page 39 "Accessories").
25