Routing Information Protocol (Rip) Commands - Hirschmann PowerMICE Reference Manual

4.6 Routing Information Protocol (RIP) Commands

This chapter provides a detailed explanation of the RIP commands. The commands are divided by
functionality into the following different groups:
Show commands are used to display switch settings, statistics and other information.
Configuration Commands are used to configure features and options of the switch. For every con-
figuration command there is a show command that will display the configuration setting.
Copy commands are used to transfer configuration and informational files to and from the switch.
4.6.1 enable (RIP)
This command sets the administrative mode of RIP in the router to active.
Default
Format
Mode
4.6.1.1 no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format
Mode
4.6.2 ip rip
This command enables RIP on a router interface.
Default
Format
Mode
4.6.2.1 no ip rip
This command disables RIP on a router interface.
Format
Mode
4.6.3 auto-summary
This command enables the RIP auto-summarization mode.
Default
Format
Mode
4.6.3.1 no auto-summary
This command disables the RIP auto-summarization mode.
Format
Mode
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
enabled
enable
Router RIP Config
no enable
Router RIP Config
disabled
ip rip
Interface Config
no ip rip
Interface Config
disabled
auto-summary
Router RIP Config
no auto-summary
Router RIP Config
36