Distance Rip - Hirschmann PowerMICE Reference Manual

4.6.4 default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
Mode
4.6.4.1 no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
Mode
4.6.5 default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format
Mode
4.6.5.1 no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format
Mode

4.6.6 distance rip

This command sets the route preference value of RIP in the router. Lower route preference values are
preferred when determining the best route.
Default
Format
Mode
4.6.6.1 no distance rip
This command sets the default route preference value of RIP in the router.
Format
Mode
4.6.7 distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Default
Format
Mode
4.6.7.1 no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
default-information originate
Router RIP Config
no default-information originate
Router RIP Config
default-metric <0-15>
Router RIP Config
no default-metric
Router RIP Config
15
distance rip <1-255>
Router RIP Config
no distance rip
Router RIP Config
0
distribute-list <1-199> out {ospf | bgp | static | connected}
Router RIP Config
37