Ip Rip Send Version - Hirschmann PowerMICE Reference Manual

Format
Mode

4.6.10 ip rip send version

This command configures the interface to allow RIP control packets of the specified version to be sent.
The value for <
1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for sending RIP
version 2 using multicast, or none to not allow any RIP control packets to be sent.
Default
Format
Mode
4.6.10.1 no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be sent.
Format
Mode
4.6.11 hostroutesaccept
This command enables the RIP hostroutesaccept mode.
Default
Format
Mode
4.6.11.1 no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format
Mode
4.6.12 split-horizon
This command sets the RIP split horizon mode.
Default
Format
Mode
4.6.12.1 no split-horizon
This command sets the default RIP split horizon mode.
Format
Mode
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
no ip rip receive version
Interface Config
> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version
mode
rip2
ip rip send version {rip1 | rip1c | rip2 | none}
Interface Config
no ip rip send version
Interface Config
enabled
hostroutesaccept
Router RIP Config
no hostroutesaccept
Router RIP Config
simple
split-horizon {none | simple | poison}
Router RIP Config
no split-horizon
Router RIP Config
39