Extron electronics Quantum Ultra User Manual page 59

Command
IP Setup
NOTES:
•
Unless noted, all commands apply to LAN A.
•
After adjusting any IP setting, enter the network reboot command
Set unit name
24
NOTES:
•
Up to 15 characters are permitted.
•
No blank or space characters are permitted.
•
No distinction is made between upper- and lowercase.
•
The first character must be an alpha character (A-Z, a-z). The last character cannot be a hyphen.
View unit name
View hardware (MAC)
address for LAN A
View hardware (MAC)
address for LAN B
Set verbose mode
View verbose mode
Set DHCP to On
24
Attempting to set the IP address, subnet mask, or gateway address while DHCP is on results in an E14 error.
NOTE:
Set DHCP to Off
24
View DHCP mode
Set IP address
24
View IP address
24
NOTES:
X1)
= DHCP status: 1 = On, 0 = Off.
X11@
= Name — Text string of up to 15 characters: A-Z, 0-9, and hyphen (-).
X11#
= IP address (nnn.nnn.nnn.nnn). Leading zeros in each of the four octets are optional in setting values and are
suppressed in returned values.
X11*
= Hardware (MAC) address (00-05-A6-xx-xx-xx)
X12@
= Verbose mode: 0 = None (default for LAN connections), 1 = Verbose mode (default for RS-232 connection),
2 = Tagged response for queries, 3 = Verbose mode and tagged response for queries (see
command definition
Quantum Ultra Videowall Processing System • Remote Configuration and Control
ASCII Command Response
(Host to Processor) (Processor to Host)
E X11@ }
CN Ipn •
E } X11@ ]
CN
In verbose modes 2 and 3:
Ipn •
E } X11* ]
1CH
In verbose modes 2 and 3:
Iph 1 *
E } X11* ]
2CH
In verbose modes 2 and 3:
Iph 2 *
E X12@ }
CV Vrb
E } X12@ ]
CV
In verbose modes 2 and 3:
Vrb
E }
1DH Idh 1
E }
0DH Idh 0
E } X1) ]
DH
In verbose modes 2 and 3:
Idh
E X11# }
CI Ipi •
E } X11# ]
CI
In verbose modes 2 and 3:
Ipi •
on page 45 for more information).
Additional Description
E ]
1BOOT for the command to take effect.
X11@ ] Specify a name for the unit.
View the name of the unit.
X11@ ]
View unit media access code
(MAC) address
LAN A port.
X11* ]
View unit media access code
(MAC) address
LAN B port.
X11* ]
X12@ ] Set the verbose mode.
View current verbose mode
X12@
X12@ ]
] Enable Dynamic Host
Configuration Protocol (DHCP) to
enable automatic assigning of IP
addresses.
] Disable DHCP automatic IP
address assignment.
View the DHCP status: On or
Off.
X1) ]
X11# ]
Set IP address
View unit IP address
X11# ]
X11*
for the
X11*
for the
.
X11#
for the unit.
X11#
.
V
erbose mode
51