Table of Contents
Advertisement
Run the MXR cable through
the notch on the front of the
Motor chassis
Attaching the Bezel to the Motor Chassis
FIG. 14
NOTE: In some cases, one or more of the mounting holes on the Bezel/Motor chassis assembly may be obstructed and
impossible to access for installing Mounting Screws. The MXR-1001 can be installed securely without using all 11 mounting
screws. Always use as many of the Mounting Screws as possible and verify that the Bezel is secured to the Motor chassis.
8.
Plug the MXR Cable from the Bezel into the connector on the front panel of the Motor chassis (beneath the mounting surface
- see FIG. 12).
9.
With the Motor & Bezel assembly positioned in the mounting surface, use the 2 included Mounting Clamps to secure the
assembled unit to the mounting surface. The Mounting Clamps slide into the two matching (ratcheted) Clamp Slots on each
side of the Motor chassis. To install the Mounting Clamps on the sides of the Motor chassis:
mounting surface
Clamp Slots and Side Clamp (X4)
FIG. 15
Insert each Mounting Clamp into a ratcheted Clamp Slot from the bottom, and slide each clamp up as far as possible, until
a.
the rubber foot on each Clamp contacts the underside of the mounting surface (see FIG. 15).
Tighten the thumb screws on all Mounting Clamps to secure the MXR-1001 to the surface (FIG. 16):
b.
MXR-1001 - Installation & Hardware Reference Manual
Bezel
(bottom side)
Clamp Slot (x4)
(2 on front/rear panels
of the Motor chassis)
Motor chassis
Motor chassis
Release Tab
Mounting Clamp (x4)
Installing the MXR-1001
Use Mounting Screws to secure all four
sides of the Bezel to the Motor chassis
Plug the MXR cable
into the connector on
the Motor chassis
Rubber Foot
Thumb Screw
17
Advertisement
Table of Contents
