Connect Ethernet, Usb And Power Cables - AMX MXR-1001-SL Installation & Hardware Reference Manual

MXR-1001 - Installed (side view)
FIG. 16

5) Connect Ethernet, USB and Power Cables

Once the MXR-1001 is installed, plug in the Power, Ethernet and (optionally) USB cable(s). These connectors are all located on the
rear panel of the Motor chassis.
Power (3-Pin Captive Wire): Connect to the included PSR2.5 24VDC external power supply. For pinout information on this

connector, refer to the MXR-1001 Hardware Installation Guide.
Ethernet (RJ45): Use a CAT5 Ethernet cable to connect the MXR-1001 to a Gigabit Ethernet Switch. For information on

pinouts, signals, and LED blink patterns for this connector, refer to the MXR-1001 Hardware Installation Guide.
NOTE: Clip the included snap-on cable Ferrite onto the Ethernet cable as close as possible to the Ethernet (RJ45) connector on
the rear panel.
USB (Type A, x2): For firmware upgrades, touch panel file transfers, JPEG image viewer, and HID Peripherals.

NOTE: If the MXR-1001 is not connected to a Master, the physical pushbutton can still be used to raise/lower the panel.
MXR-1001 - Installation & Hardware Reference Manual
Mounting Clamp (x4)
(2 on each side)
Clamp Slot (x4)
(2 on front/rear panels
of the Motor chassis)
front
Installing the MXR-1001
Rubber Foot
Thumb Screw
Release Tab
Motor
chassis
mounting
surface
18