Installing The Nxa-Avb/Ethernet - AMX NXT-CV10 Operation/Reference Manual

CV10 Touch Panel Accessories
NXA-AVB/ETHERNET Product Specifications (Cont.)
Rear Components:
Included Accessories:
Other AMX Equipment:

Installing the NXA-AVB/ETHERNET

A 12 VDC-compliant power supply can indirectly provide power to a Modero panel by routing power through
the NXA-AVB/ETHERNET Breakout Box. FIG. 5 shows a sample wiring configuration using both an indirect
or direct power connection for a video-capable Modero panel.
Indirect
Connect
12 VDC power
supply
supplied via
NXA-AVB box
12 VDC power
supply
Direct
Connect
FIG. 5 Sample wiring configuration on video-capable panels using this breakout box
A 12 VDC-compliant power supply can also directly provide power through the unit to a target Modero panel.
FIG. 6 shows a sample wiring configuration for a non-video capable Modero panel.
Direct
connect
12 VDC power
supply
FIG. 6 Sample wiring configuration using CA Modero panels
8
• 6-pin 3.5 mm Phoenix connector for in-bound (left/right channel) audio
• 4-pin 3.5 mm Phoenix connector for out-bound (from microphone) audio
• BNC connector (female) for Composite or Chroma (for video-capable
panels only)
• BNC connector (female) for luminance (for video-capable panels only)
• RJ-45 connector for Ethernet input from the control system
• 2-pin 3.5 mm Phoenix connector for in-bound power
• Two 2-pin Phoenix connectors (41-5025)
• 4-pin Phoenix connector (41-5047)
• 6-pin Phoenix connector (41-5063)
• Rack Mount Kit (KA2250-40) with mounting bracket (62-2254-02)
• AC-RK Accessory RackMount Kit (FG515)
• Modero Table Top Cable (CA2250-50)
Ethernet In
(RJ-45)
Video In
(BNC)
NXA-AVB/ETHERNET
Breakout Box
Power
Ethernet
(CAT5)
or
NXD/T Video-capable
Touch Panels
Ethernet
(CAT5)
NXD/T Non-video capable
Touch Panels
Line Level out
Mic Out
(to amplifier
(4-pin captive-wire)
or VOL card)
Audio In
(6-pin captive-wire)
(rear)
(front)
Audio/Video
(CAT5)
Audio (CAT5)
between the
NXA-AVB/ETHERNET
Breakout Box
10" Modero Touch Panels