Table of Contents
Advertisement
Positioning the Motor beneath the Cutout
FIG. 13
3.
Carefully lift the Motor chassis up so that the top of the chassis fits into the cutout and is flush with the top of the mounting
surface.
4.
Position the Bezel directly above the cutout hole. Verify that the Bezel is oriented correctly relative to the Motor chassis - the
pushbutton is located on the front of the Bezel.
5.
Route the MXR cable from the Bezel through the slot on the front center of the Bezel, and run it through the cutout hole.
6.
Lower the Bezel through the cutout hole and slide it onto the top of the Motor chassis.
7.
Secure the Bezel to the Motor chassis using all 11 supplied mounting screws - there are 3 mounting holes on the front, 4 on
the back, and 2 on each side (FIG. 14):
MXR-1001 - Installation & Hardware Reference Manual
Bezel
(above mounting surface)
Motor chassis
(beneath the
mounting surface)
front
Installing the MXR-1001
mounting surface
Cutout hole
16
Advertisement
Table of Contents
