Digital Alert Systems DASDEC II User Manual page 95

combination of these options will work when streaming to a remote DASDEC II EAS NET decoder. The
default is to not stream the header or EOM sequence, just the audio voice message. Use the options as
required by the specific application on a remote server.
To review, the options allow the inclusion/exclusion of:
1. Pre-Alert audio/EAS Alert FSK header/Alert Attention signal
2. EAS alert FSK EOM.
Delay time before stream start; Starting silence duration; Ending silence duration: This option
allows streaming to be delayed by the duration of the alert header. Three numeric text fields allow entry
of three additional audio delay components. Each delay is in seconds and applies to a specific location
during the audio stream. Use as needed for the specific application.
3. Configure EAS NET Clients
Two toggles are displayed for enabling EAS NET during alert forwarding and origination.
Alert Forwarding to EAS_NET devices
This toggle enables EAS NET send processing during alert forwarding. It can be enabled / disabled at any
time.
Encoder Originated Alerts Sent to EAS_NET devices
This toggle enables EAS NET send processing during alert origination. It can be enabled / disabled at any
time.
Decoded Alerts Can be sent to EAS_NET devices
This toggle enables EAS_NET send processing during alert decoding. Decoded alerts can be sent to
another EAS_NET device without forwarding and putting it on the air.
NOTE: At least one of these toggles must be enabled to allow editing of EAS NET clients. In
the screen shot below, both toggles are enabled.
Digital Alert Systems: DASDEC User Manual
Setup > Net Alerts > EAS NET Configure EAS Web audio streaming
89