Digital Alert Systems DASDEC II User Manual page 36

To use this interface correctly, you must add client interface descriptors for each remote platform in the managed
group. The
there is no need to confirm the addition. The screen shot below shows a single remote client descriptor that was
added using
Once a remote host client descriptor interface is added, it must be configured. Reasonable default values for
SSH connection to the remote host are provided (except for IP address). Type in the IP Address and change the
remote host User name, the SSH configuration path (directory), the SSH authorized keys file name, DSA public
key and private key file names, and management status file name if needed.
Changes to these Host text field values are not saved until you click
cancel changes by clicking the
A very useful feature of this interface is that it provides network connection tests to remote hosts. Set the selector
SSH Connection Test to the desired test and click the button
You can try a variety of tests to prove SSH connectivity as well as network connectivity via "ping". Six tests are
supported:
1. "Ping". Use a simple network ping to test if the base network route to a remote host exists. To test
basic network connectivity, the ping test can be used without regard to the SSH field configuration.
Set the IP address (numeric dot.decimal format unless DNS is enabled) and run the Ping test using the
2. "Uname" query via SSH (see example above). This will attempt to get the operating system name from
the remote host.
3. "Date" query via SSH. This will attempt to get the date and time from the remote host.
4. SCP test via SSH. This will attempt to copy a test file to the remote host.
5. "Key Management Status" query via SSH. This will attempt to retrieve the current state of the DASDEC
II key management status from the remote host.
6. "Get Public Key" query via SSH. This will attempt to retrieve the public key from the remote host.
Select a test and click the
run some of these tests. Results are printed just below the
30
button is used to create each descriptor. When a descriptor is added using this button,
. Add as many as descriptors as needed. (EAS NET allows up to 8 connections.)
SSH Key Management Interface
button.
button to see the test results. Be patient; it can take several seconds to
button.
button.
Digital Alert Systems: DASDEC User Manual
.
. You can