Stream Mpeg - Digital Alert Systems DASDEC II User Manual

All EAS codes trigger
If enabled, all EAS codes will trigger the DVS644/SCTE18 client interface. In the next screen shot this option is
enabled. Set the checkbox to enable/disable EAS code filtered trigger control. If disabled, then the alert EAS
code is filtered for a specific match as a way to control whether or not DVS644/SCTE18 is triggered. If All EAS is
disabled, select EAS codes from the provided lists and add to the client EAS list. If the EAS codes of an active
forwarded/originated alert matches any of these EAS, the alert will be sent using the DVS-644/SCTE18 client.
With careful use of this feature, and with multiple clients, one DASDEC II can serve many different cable regions
at the same time.
When you finish making changes, click

4.10.5 Stream MPEG

If Streaming MPEG hardware/software is available on the One-NetSE, a tabbed page will display under Setup >
Net Alerts that allows configuration of up to two client targets. As in the other Net Alert pages, use the Alert
Forwarding and/or the Encoder Alert Stream toggles to enable/disable the use of streaming MPEG clients when
alerts are forwarded and/or originated.
104
DVS-644/SCTE18 Client Configuration Interface, bottom half of table
to save the configuration.
Digital Alert Systems: DASDEC User Manual