Channel Scan Skip; Frequency Reverse - AnyTone THE OBLITERATOR OBLTR-8R User Manual

SHORTCUT OPERATIONS
▼ Frequency/channel scan can change the scanning direction by rotating the channel knob, If a signal is
found the transceiver will stay 5 seconds then continue scanning. (Please refer to scan setup)
▼
Frequency scan can be limited to UHF / VHF if you have the single band mode enabled (See: Function
Menu - Single Band Mode (VHF/UHF)
▼
Frequency Scan can also be limited to your pre-set scanning border limits (See: Limit VFO frequency
scanning range)
▼
If turn off radio in scan mode, when re-power on, radio will resume scanning automatically.

Channel Scan Skip

Under channel mode, press
key to set current selected channel as Channel scan skip. Repeat
then press
above operation to cancel channel scan skip.
LCD displayed "
1.
S " means the current channel will not be scanned.
2.
S
" " icon disappeared means the current channel will be scanned.

Frequency Reverse

When in standby, press
key to set arrow directed channel as frequency reverse, repeat
then press
above operation to turn off frequency reverse.
When LCD displays "
1.
reverse function enabled, the TX frequency and RX frequency are reversed, if CTCSS/DCS signaling is
key, the top left corner of LCD displays "
key, the top left corner of LCD displays "
R" icon, it means current selected channel has the frequency
" icon,
" icon,
29