Add/Cancel Optional Signal Decode Function - AnyTone THE OBLITERATOR OBLTR-8R User Manual

SHORTCUT OPERATIONS
NOTE：AM/SW/LW require another antenna (For Optimal Performance). Also when you are in an AM
mode (AM/LW/SW), the sub-band UHF/VHF channel will be occupied for the AM monitoring.

Add/Cancel Optional signal decode function

When in standby, press
press key.
The LCD displays
1.
current channel.
Repeat the above operation, the LCD displays
2.
5TONE signaling has been added in current channel.
Repeat the above operation, the LCD displays
3.
added in the current channel.
(TERMN-8R ONLY) Repeat the above operation, the LCD displays
4.
has been added in the current channel.
Repeat the above operation, the LCD displays
5.
has been added in current channel.
NOTE: When this function is on, the user must setup the SIGNAL menu to use the TONE option, then
DTMF/5TONE/2TONE/MSK can be used (For decoding). The programming software is required to set the
tones needed if you require specific optional signaling.
26
key, the top left corner of LCD displays "
" icon, DTMF signaling has been added in the
"DTMF" and "
T
"5TONE" and "
T
" icon, the 2TONE signaling has been
"2TONE" and "
T
"MSK" and "
"OFF", the " " icon disappears, and no optional signaling
T
" icon,
" icon, the
" icon, MSK signaling
T