FUNCTION MENU SETUP
Self ID inquiry
key, the top left corner of LCD displays "
1. Press
2. Press
/
LCD.
3. Rotate channel selector knob to choose desired setup.
The ID code displaying on LCD is transceiver self ID code.
4. Press
key or
NOTE: When current channel add 5TONE to be optional signaling, LCD displays 5TONE self ID code,
otherwise displays DTMF self ID code.
Tone Pulse Frequency Selection
This function is used for waking up a repeater that requires a tone burst. You will need to know if your
repeater requires a tone burst and the tone required. In general, as long as the repeater has been activated,
there is no need to transmit the Tone Pulse again until a preset time has expired.
key, the top left corner of LCD displays "
1. Press
2. Press
/
on LCD.
3. Rotate channel selector knob to choose desired setup.
1750HZ, 2100HZ, 1450HZ, 1000HZ - These are the 4 settings you can set as
required by your local repeater.
4. Press
key or
68
key to choose NO.31(OBLTR-8R)/NO.46(TERMN-8R) function item, it shows "ID" on
key to conirm and exit.
key to choose NO.32(OBLTR-8R)/NO.47(TERMN-8R) function item, it shows "TBST"
key to conirm and exit.
" icon, then press
" icon, then press
key enter into function menu.
key enter into function menu.