AnyTone THE OBLITERATOR OBLTR-8R User Manual page 49

FUNCTION MENU SETUP(OBLTR-8R)
TALKAR
12 Talk Around
Offset Frequency
OFFSET
13
setup
Editing Channel
14
NAME
name
Busy Channel
RPLOCK
15
Lockout
TX OFF
16 TX
Single Band Mode
17 BAND
(VFO) (VHF/UHF)
18 (VHF/UHF)
DSPSUB
Keypad Voice
19 BEEP
prompt setup
38
Turn on Talk Around function, current channel will
transmit at RX frequency, if CTCSS/DCS signaling
TX=RX
is set, it will interchange decoding CTCSS/DCS as
encoding.
OFF
Close Talk Around function.
Note: It is available to setup in Programming software.
0-70MHz
RX:UHF, TX:VHF or RX:VHF, TX:UHF
In channel name display mode, will display the
a-Z, 0-9
edited channel name.
Carrier wave lock, transmitting is prohibited when
BUSY
received matching carrier wave.
Signaling lock, transmitting is prohibited when
REPEAT
received matching carrier but with mismatching
CTCSS/DCS
OFF Close BCLO function
ON/OFF
TX function is enabled/disabled in current channel.
ON/OFF
Turn on/off band limit function
FREQ Display sub band frequency or channel
VOLT
Display current battery voltage
OFF
Sub band display is disabled
ON/OFF
Turn on/off keypad voice prompt function