Cajun Campus Cli - Layer 2; User Level Commands - Avaya P333T User Manual

Chapter 6
Cajun Campus CLI – Layer 2
This chapter provides instructions for the configuration of your Avaya P330 using
the text-based Cajun Campus Command Line Interface (CLI or Terminal
Emulation). You can also configure your Avaya P330 using the Embedded Web
Manager with its graphical user interface (see Appendix A).
The configuration procedure involves establishing a Telnet session or a serial
connection and then using the Avaya P330's internal CLI. See Chapter 5 for
instructions on how to establish a Telnet session or serial connection, and for a
description of CLI conventions.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, you must type the desired command at the prompt and press
Enter.

User Level Commands

This section describes all commands that are available from the User level.
Following is a table of the User Level commands and command groups (all
commands are also available at the higher levels).
• session
• terminal width
• terminal length
• clear screen
1
• show
• ping
• dir
1 This command corresponds to a group of commands and is shown in a separate
Table on Page 41
Avaya P333T User's Guide
Opens a session to another Avaya P330
module or X330 ATM Access module
Display or set the width of the terminal
display
Display or set the length of the terminal
display
Clears the current terminal display
Shows the current switch parameters
Sends ICMP echo request packets to another
node on the network
Show files in the System
Page 40
Page 40
Page 40
Page 41
Page 41
Page 41
Page 68
39