Event Setup - Ganz digimaster DR-4FX1 Operation Manual

Event Setup

Define various events, and specify the conditions to notify the user in various ways.
Alarm Out
Specify the alarm output conditions with the work schedule.
 Number of alarm output is different on each models.
DR-16FX2
DR-16FX5
1. From <SYSTEM SETUP> - <EVENT>, select
<ALARM OUT>.
2. Use the [▲▼◀▶/ENTER] buttons on the
remote control or use the mouse to select
<ALARM OUT>and configure the related settings.
>NAME : You can rename the alarm.
>OPERATION : Set the alarm output mode.
- N/O (Normal Open) : It normally stays Open.
If an event occurs, it will switch to Close.
- N/C (Normal Close) : It normally stays Close.
If an event occurs, it will switch to Open.
>DURATION : Specify the duration of the alarm output.
- TRANSPARENT : Keep the alarm out for as much time as the event lasts.
- UNTIL KEY : Keep the alarm out until a mouse or remote control button is pressed.
- 5 ~ 300 SEC : Keep the alarm out for as long as specified.
>TEST : Forcibly output the alarm for the test purpose.
3. To apply the change, click <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> button.
The confirmation message appears and you will return to the previous menu.
Model Relay output
DR-4FX1
DR-8FX2
DR-8FX5
Alarm (TTL) output
1 N/A
1 N/A
1 N/A
4
8
System Setting
4
8
３７