Ganz digimaster DR-4FX1 Operation Manual page 15

Motion Sensor
Set the motion sensor of the camera so that it can
detect a motion event.
1. From <SYSTEM SETUP> - <CAMERA>, select
<MOTION SENSOR>.
2. Use the [▲▼◀▶/ENTER] buttons on the remote
control or use the mouse to specify the use of each
option item.
> ACTIVATION : turn on or off the motion sensor.
> MOTION MARK: Set it to <On>.
The video window will display the motion mark if a motion is detected.
> SENSITIVITY : Set the sensitivity level of the motion sensor to either Daytime or Nighttime.
> EDIT AREA : Specify the motion detection area.
3. To apply the change, click <APPLY> button.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> button.
The confirmation message appears and you will return to the previous menu.
 The motion detection sensitivity may differ depending on the characteristics of the
connected camera or installation environment.
Motion Area Setup
From the motion setup window, click <EDIT AREA> in the right corner.
1. Click <EDIT AREA> to move to the motion
area setup screen.
2. If using the remote control, press the [ENTER]
button to mark the current position.
3. Use the arrow buttons to move to a desired block
and press [ENTER]. The area setup will begin.
Then, use the arrow buttons to specify the area.

Alternatively, you can use the drag-and-drop
method to specify or release the area using
mouse.
4. If you select the specified area again, it will be released.
5. Press the [EXIT] button on the remote control or
right-click any area to display the popup window
as in the right picture.
System Setting
１５