Ganz digimaster DR-4FX1 Operation Manual page 42

System Setting
Motion Sensor
You can set an action to execute when a motion is detected. For the settings of the motion sensor,
move to <CAMERA SETUP>.
1. From <SYSTEM SETUP> - <EVENT>, select
<MOTION SENSOR>.
2. Use the [▲▼◀▶] buttons on the remote control
or use the mouse to specify the ignorance interval
and operation.
>IGNORING INTERVAL : Specify the minimum
interval of the motion event occurrence.
For example, even if you have set the minimum
frequency to 5 seconds and another motion event
occurs in less than 5 seconds after the last motion
event occurred, the new event will be ignored.
If too many motion events occur, adjust to shorten the interval.

Motion recording will be triggered immediately after the motion occurred regardless of the
above settings.
>ALARM OUTPUT : Specify the alarm output channel if a motion is detected by the motion sensor.
>BUZZER : Specify the output of the buzzer if a motion is detected by the motion sensor.
>VIDEO POPUP : Select to display the video popup if a motion is detected by the motion sensor.
>EMAIL : Select to send an email if a motion is detected by the motion sensor.
>FTP : Select whether to upload event notification onto the FTP upon detected motion event.
3. To apply the change, click <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower
screen. The confirmation message appears and you will return to the previous menu.
Video Loss
You can specify a reaction to the case where no video is received from the camera.
1. From <SYSTEM SETUP> - <EVENT>, select
<EVENT LOSS>.
2. Use the [▲▼◀▶] buttons on the remote control or
use the mouse to specify the reaction to a video loss.
>ALARM OUTPUT : Specify the alarm output
channel if a video loss occurs.
>BUZZER : Specify the output of the buzzer if a
video loss occurs.
>EMAIL : Select to send an email if a video loss
occurs.
>FTP : Select whether to upload event notification onto the FTP upon detected video loss
event.
3. To apply the change, click <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower
screen. The confirmation message appears and you will return to the previous menu.
４２