Storage - Ganz digimaster DR-4FX1 Operation Manual

System Setting

Storage

You can configure the settings of and view information of the disk and external storage device.
2U model (DR8/16FX5) supports both <INTERNAL> and <EXTERNAL STORAGE>.
Disk Information
It will show information about the connected disk.
1. From <SYSTEM SETUP> - <STORAGE>,
select <DISK INFORMATION>.
2. Use the [▲▼◀▶/ENTER] buttons on the remote
control or use the mouse to check each connected
peripherals.
>START / END TIME : show the start time and end
time of data stored in each disk.
>STATUS : check if the connected disk is being
used by the DVR. If you encounter a problem with
the disk, the DVR will terminate the connection to
the disk and mark it as 'Not In Use'.
>CAPACITY : show the capacity of the disk.
>MODEL : indicate the disk model.
>S.M.A.R.T STATUS : Read the S.M.A.R.T
information of the disk and check to display if the
current disk is in normal operation.
- NORMAL : The disk is in a normal state.
- CHECK : The disk has an error so that you need to check the disk or the connection cables of
the disk. If you leave the problem unresolved, no recording may be enabled.
So it is recommended that you replace the disk immediately.
- ERROR : The disk fails or is unable to use due to an error of the disk or the cable.
The disk should be replaced immediately. Contact the retailer or the customer service to
replace the disk.
3. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower
screen to return to the previous menu.
３４