Installation - Parmco PPOV-6S-PYRO-2 Installation And Operating Instructions Manual

INSTALLATION

Installing the oven
The kitchen should be dry and have effective ventilation according to the existing technical
provisions
Main lead behind the oven must be placed in such manner to avoid touching the back panel of the
oven because of the heat it develops during operation
Remove any packaging materials (foils, artificial foam, nails, etc.) from the reach of children,
because they represent potential danger. Children may swallow small parts, or suffocate with
foils/plastics.
This is a built-in oven, which means that its back wall and one side wall can be placed next to a
high piece of cabinetry or a wall.
Coating or veneer used on fitted cabinetry must be applied with a heat resistant adhesive (100℃).
This prevents surface deformation or detachment of the coating. If you are unsure of your
cabinetry's heat resistance, you should leave approximately 2cm of free space around the oven.
The wall behind the oven should be resistant to high temperatures. During operation its back side
can warm up to around 500℃ above the ambient temperature.
Make an opening with the dimensions given in the diagram for the oven to be fitted
The appliance must be earthed.
Insert the oven completely into the opening without allowing the four screws in the places shown
in the diagram to fall out.
5