Page 1
Installation and Operating Instructions Models: OV-1-6S-GAS OV-1-6W-GAS As part of Parmco Appliances commitment to improving and updating product ranges, we reserve the right to alter, change and update technical specifications and appearance attributes of all Parmco Appliances products. E&OE. 727626122011...
Regulatory Requirements with particular reference to the New Zealand Electrical and Gas Installation Standards. Any attempt to install this or any other Parmco product without an authorised person could result in damage to the product and a possible health hazard. Not having an authorized person install this appliance may result in all associated warranties from Parmco Appliances being null and void.
We recommend that for best performance and to extend the life of your appliance, you read the instructions in this owners manual thoroughly before using your new appliance. It will provide you with all the information you need to ensure its safe installation, proper use and maintenance. Retain this owners manual for future reference.
Page 5
• DO NOT USE OR STORE FLAMMABLE MATERIALS IN THE APPLIANCE OR NEAR THIS APPLIANCE. For any enquiries please contact Parmco Appliances (09) 573 5678. For this oven to function correctly, it is critical that the primary airflow to the upper and lower burners is correctly adjusted.
USE AND CARE PRECAUTIONS AND GENERAL ADVICE When the oven and grill are used for the first time, they should be heated to the maximum temperature for approximately 45 minutes to burn off any oily residues left by the manufacturing process.
USING THE GAS OVEN Cooling Fan System The appliance is equipped with a cooling system which comes into operation a few minutes after the oven is lit. The fan generates an airflow, which comes out above the door and may continue for a short time even after the oven is turned off.
Page 8
Using the Grill and Rotisserie Fit the spit rod into the rotisserie bushing and select grill function. Using the Rotisserie in cookers with normal oven. Place the rotisserie shelf “B” on the second pair of runners from the bottom and fit the rod “A” into the hole in the back of the oven.
NOTE: Place the baking tray provided on the bottom shelf position to prevent any spillages from dripping onto the bottom of the oven. Never place anything (including foil and oven trays) directly onto the bottom of this oven when it is in operation as this could damage the enamel. Only place your cookware (dishes, trays, aluminium foil etc) on the oven shelves provided with this appliance.
There is a rubber seal surrounding the oven. Check the condition of the seal on a regular basis. If necessary, clean it but avoid using abrasive products or objects to do so. Should it become damaged, please contact Parmco Service Department. We recommend you avoid using the oven until it has been repaired.
For this reason, we strongly advise you to contact Parmco Service Department, specifying the nature of the problem, the model and serial number of the appliance. This data is provided on the data label adhered to the base of the appliance and on the duplicate data label in the operating pack.
New Zealand Electrical Standards. Any attempt to install this or any other Parmco product without an authorized person could result in damage to the product and possible health hazard. Not having an authorized person install this appliance may result in all associated warranties from Parmco Appliances being null and void.
Page 13
are in breach of the regulations in force or from failure to comply with these installation instructions. Electrical Connection It is necessary that all installation and connections are carried out by qualified personnel and that the connections meet all New Zealand Regulatory Requirements. Before connecting to the mains, make sure that;...
Page 14
In order to ensure adequate ventilation, the back panel of the cabinet unit must be removed. Installing the oven so that it rests on two strips of wood is preferred. If the oven will rest on a continuous panel, there must be an aperture of at least 560mm wide by 45mm deep from the rear of the cabinet.
Page 15
Room Ventilation The appliance may only be installed in a permanently ventilated room as specified by the relevant regulations. The airflow into the room must be sufficient for proper gas combustion and room ventilation. The air intake, protected by gratings, must be of suitable size (see relevant regulations) and located so that they are not obstructed in any capacity.
Page 16
Adjusting the Minimum Setting (Before adjusting the minimum setting, it is critical that the primary airflow has been adjusted correctly. Please see below.) The oven thermostat has a screw for regulating the minimum setting, accessed by removing the thermostat knob. When the type of gas used changes, the minimum setting must be adjusted as follows: •...
Page 17
The regulator sleeve should be adjusted such that there is no flame “flicker”. The flame should be stable and even. Burner and Nozzle Data Table Bottom Burner Burner Rated Heat Capacity Bottled Gas (LPG) – G30/G31 28/37 mbar (kW) (MJ/h) Nozzle By-pass Reduced...
09 573 5678 f: 09 573 5699 e: sales@parmco.co.nz w: www.parmco.co.nz Parmco Appliances extended 5 year warranty The Warranty: The Warranty is not valid: • If the product is not installed and operated in accordance with the operating • Subject to the terms and conditions contained within this instructions. warranty, if the product is not of Acceptable Quality (as • If the product is not installed to comply with the electrical, gas, plumbing defined in the Consumer Guarantees Act) within 5 years of and other Regulations and Codes of Practice in New Zealand. the date of original purchase, then Parmco Sales undertakes • If the product is operated on voltages or frequencies outside the normal range for domestic appliances in New Zealand. to repair or, at it’s sole discretion, replace the product.
Need help?
Do you have a question about the OV-1-6S-GAS and is the answer not in the manual?
Questions and answers