Cleaning And Maintenance - Parmco PPOV-6S-PYRO-2 Installation And Operating Instructions Manual

CLEANING AND MAINTENANCE

By ensuring proper cleaning and maintenance of your oven you can have a significant influence
on the continuing fault-free operation of your appliance.
Before you start cleaning, the oven must be switched off and you should ensure that all knobs are
set to the "0"position. Do not start cleaning until the oven has completely cooled.
Oven
●
The oven should be cleaned after each use (not pyrolytic clean).
●
Cool the oven completely before cleaning.
●
Never clean the appliance with pressurized hot steam cleaner.
●
The oven chamber should only be washed with warm water and a small amount of washing-up
liquid and completely dried.
●
Steam cleaning
-pour 250ml of water (1 cup) into a bowl placed in the oven on the first level from the bottom.
-Close the oven door.
-Set the temperature knob to 50℃, and the function knob to the bottom heater position.
-Heat the oven chamber for approximately 30 minutes.
-Open the oven door, wipe the chamber inside with a cloth or sponge using warm water with
washing-up liquid.
●
After cleaning the oven chamber wipe it dry.
Caution
Do not use cleaning products containing abrasive materials for the cleaning and maintenance of
the glass front panel.
Replacement of the oven light Bulb
Before any maintenance is started involving electrical parts, the appliance must be disconnected
from the power supply.
If the oven has been in use, let the oven cavity and the heating elements cool down before
attempting any maintenance.
Changing the bulb
Pull out the protective cover. We recommend that you wash and dry the glass cover at this point.
Carefully remove the old bulb and insert the new bulb suitable for high temperatures (300ºC)
having the following specifications: 220-240V, 50Hz, 25W, G9 fitting.
Refit the protective cover.
16