Mitsubishi Electric FR-E700 Basic Instruction Manual page 73

Make a start and stop with terminals (external operation)
REMARKS
[EXT] is not lit even when
Switchover of the operation mode with
50Hz for the RH, 30Hz for the RM and 10Hz for the RL are not output when they are turned ON...Why?
Check for the setting of Pr. 4, Pr. 5, and Pr. 6 once again.
Check for the setting of Pr. 1 Maximum frequency and Pr. 2 Minimum frequency once again. (Refer to page 45)
Check for the Pr. 79 setting once again. Pr. 79 must be set to "0" or "2". (Refer to page 47)
Check that Pr. 180 RL terminal function selection ="0", Pr. 181 RM terminal function selection ="1", Pr. 182 RH terminal function
selection ="2" and Pr. 59 Remote function selection ="0". (all are initial values)
[RUN] is not light...Why?
Check that wiring is correct. Check it again.
Check that "60" is set in Pr. 178 STF terminal function selection (or "61" is set in Pr. 179 STR terminal function selection). (all are
initial values)
How is the frequency setting from 4 to 7 speed?
The setting differs according to Pr. 24 to Pr. 27 (multi-speed setting).
(applied).
Perform multi-speed operation more than 8 speed...How?
Use the REX signal to perform the operation.
External operation is fixed by setting "2" (External operation mode) in Pr. 79 Operation mode selection when you do not want to
take time pressing
64
is pressed...Why?
is valid when Pr. 79 = "0" (initial value).
or when you want to use the current operation command and frequency command. (Refer to page 47)
Refer to the chapter 4 of the Instruction Manual
Refer to the chapter 4 of the Instruction Manual (applied).