Mitsubishi Electric FR-E700 Basic Instruction Manual page 75

Make a start and stop with terminals (external operation)
POINT
When you always want to operate in the External operation mode at powering ON or when you want to save the
trouble of
operation mode always.
REMARKS
Pr. 178 STF terminal function selection must be set to "60" (or Pr. 179 STR terminal function selection must be set to "61"). (all are initial
values)
The motor will not rotate...Why?
Check that [EXT] is lit.
[EXT] is valid when Pr. 79 = "0" (initial value) or "2".
Use to lit [EXT].
Check that wiring is correct. Check it again.
Change the frequency (0Hz) of the minimum value of the potentiometer (0V initial value)
Adjust the frequency in calibration parameter C2 Terminal 2 frequency setting bias frequency. (
Instruction Manual (applied)).
66
input, set "2" (External operation mode) in Pr. 79 Operation mode selection to choose External
Refer to the chapter 4 of the