Reer MOSAIC Master M1 Installation And Use Manual page 63

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
Otherwise, enabling of the output directly follows the input conditions.
There are two types of reset: Manual and Monitored. When Manual is selected the system
only verifies the signal's transition from 0 to 1. If Monitored is selected the double
transition from 0 to 1 and then back to 0 is verified.
WARNING: If the Manual Reset is active, a consecutive Input have to be used.
Example : Input 1 and Input 2 are used for the fuctional block, then Input 3 have to
be used for the Reset Input.
OUT TEST signals cannot be used in case of safety static output ESPE because the control
is carried out from the ESPE.
Test at start-up: If selected this enables the test at start-up of the safety light curtain.
This test is performed by occupying and clearing the area protected by the safety light
curtain to run a complete function test and enable the output. This test is only requested
at machine start-up (when the unit is switched on).
Filter (ms): This is used to filter the signals coming from the safety light curtain. The filter
can be configured to between 3 and 250 ms and eliminates any bouncing on the
contacts. The length of the filter affects the calculation of the unit's total response time.
With Contemporaneity: If selected this activates the test to verify concurrent switching of
the signals coming from the safety light curtain.
Contemporaneity (ms): This is only active if the previous parameter is enabled. It defines
the maximum time (in msecs) between the switching of two different signals from the
safety light curtain.
Enable Error Out: If selected reports a fault detected by the function block.
Item description: This allows a description of the component's function to be entered. The
text is displayed in the top part of the symbol.
8540780 • 25th June 2012 • Rev.15 63