Ingenico iCT220 User Manual page 77

Terminal User Guide
To access the Config menu press the menu key twice, then
choose SUPERVISOR by pressing the F3 key. You will be asked
to type your current supervisor password, and confirm this by
pressing the enter key, and choose CONFIG by pressing the F3
key.
MENU, MENU, F3, [password], ENTER, F3

Below is a summary of the functions within the Config menu
and how to access them, and what they do.

Some Supervisor functions must only be used when

instructed to do so by the terminal Helpdesk.
First Config Menu
PRINT EMV
PRINT CERTS
SET PSTN
SCAN NETWRK
Second Config Menu (Press menu once)
SELECT N/W
Prints EMV data loaded on the terminal. Do
not use this feature unless instructed to do
so by the terminal Helpdesk.
Prints Certificates loaded on the terminal. Do
not use this feature unless instructed to do
so by the terminal Helpdesk.
Allows the telephone network (PSTN) prefix
number to be set. For further information
refer to the section entitled Telephone
Lines and Broadband.
Prints a rolling data sheet of the mobile
network. Do not use this feature unless
instructed to do so by the terminal Helpdesk.
Allow the selection of a different mobile
network. Do not use this feature unless
instructed to do so by the terminal Helpdesk.
Supervisor Functions
75