Telephone Lines And Broadband - Ingenico iCT220 User Manual

Your Terminal

Telephone Lines and Broadband

Your terminal can be used on a variety of telephone lines,
however to use your terminal on some lines you may be
required to change the telephone network (PSTN) setting in
the terminal. Your terminal is pre-configured so that it may
work on a direct telephone connection.
If your telephone line requires you to dial a 9 (for example) to
get an outside line then you are on a telephone exchange or
switchboard and will need to configure the 9 (for example) in
the terminal so it is able to dial out of the telephone exchange.
To configure the PSTN prefix, press the menu key twice, then
choose SUPERVISOR by pressing the F3 key. You will be asked
to type your current supervisor password, and confirm this by
pressing the enter key, and choose CONFIG by pressing the F3
key, followed by the SET PSTN by pressing the F3 key again.
Type in the PSTN prefix (typically 9) followed by the enter key.
MENU, MENU, F3, [password], ENTER, F3, F3

If your telephone line has Broadband (ADSL) active then you
must use an ADSL micro-filter between your terminal's
telephone line lead and your BT socket. For more information
on, and to purchase additional ADSL micro-filters you should
contact your ADSL internet service provider.
If your telephone line is shared with other equipment, such as
a telephone or fax machine, then you will not be able to use
your terminal while using the telephone line with the other
equipment. It is recommended that your terminal should be
used on a dedicated telephone line.
If your telephone line has a voicemail/answering service or call
waiting, it is recommended that these features are turned off.
It is also strongly recommended that your terminal does not
share with an alarm system (RedCare line). Your terminal may
not function correctly, and it may invalidate your alarm/
insurance policy.
18
Terminal User Guide