Page 1
Sircle POS Ingenico iCT220 Initial Setup of the iCT220 • Plug the power cable from the device into the network hub, then plug the network hub into a power outlet. Plug an Ethernet cord into the network hub where its labeled “ETH”.
Page 2
Setup with Sircle POS • Open the POS software and click settings, then “Payment Processing”. • Uncheck “Express Checkout” if selected, and open “Other Payment Processing”. • In the drop down menu select “velocityemc” and enter your “Merchant Profile ID” along with your state initials.
Page 3
Once completed, hit the back button on your tablet until you are back at the initial settings screen. • Select “Payment Device Setup”, then select “Ingenico iCT250/iCT220”. • Enter the IP address that you wrote down earlier from your Ingenico iCT220, and type 6200 for the port number. Page 3 of 3...